Guard Industry

TOTAL PROTECTION FOR POROUS AND SLIGHTLY POROUS MATERIALS

 

ImperGuard® Limestone Wall Sealer
Beading Effect

ProtectGuard® MG

$440.00$1,920.00

Clear

Description

ProtectGuard® MG Marble Sealer Granite Sealer Logo

ProtectGuard® MG Granite and Marble Sealer

Protectguard® MG is a full penetrating stone sealer for very dense, low porosity materials. It will not alter the appearance or texture of materials to which it is applied. It has excellent stain resistant properties. It will repel water, oil, grease, weak acids like juice and wine, and most common household stains. This is a premium sealer that sits right at the top of the ProtectGuard range. If you are looking for the ultimate in natural finish sealing you need look no further!

 

ProtectGuard MG Marble Sealer Granite Sealer

Protectguard® MG is the ideal sealer for dense materials such as:

  • Marble
  • Granite
  • Polished and crystallised materials
  • Stoneware
  • Porcelain
  • Low porosity silica and limestone
  • Densified and mechanically polished concrete

 

 

ProtectGuard MG Marble Sealer and Granite Sealer Project References

Additional information

WeightN/A
DimensionsN/A
Appearance

Composition

Protection Type

, ,

Size

,

Surface Area

, , , ,

Surface Type

Advantages

  • High-performance protection against water, oil and stains
  • Abrasion resistant
  • Does not form a film, lets the material breathe
  • Invisible: does not change colour
  • UV and frost resistant
  • Slows down ageing and makes maintenance easier

Uses

  • Slightly and very low porosity materials: marble, granite, sandstone, slate, polished materials, concrete, etc.
  • Floors and facades
  • New or old
  • Internal and external
  • Recommended for patios, pedestrian areas, living rooms, facades, stairs, etc.

Application

Preparing the material:

Application:

  • Use the product in its pure form: do not dilute it.
  • Shake the packaging well before use and carry out a preliminary test.
  • Apply the product in one go. Let it soak in and let the product dry (10 to 60 minutes depending on the porosity and temperature of the material).
  • Do not overload the material, remove any excess with a soft cloth dabbing the material before drying the product.
  • The surface dries in 1 hour.
  • The surface must be protected from traffic and liquids (rain, grease, etc.) for 24 hours
  • On very-low porosity or polished materials, the surface must be polished with a microfibre cloth after application.
  • Optimum efficiency of the product is obtained after 48 hours drying.

Tools Required

  • A cloth, brush, or flat microfibre brush.

Data Sheets

Safety Data Sheet

Technical Data Sheet

Reviews

There are no reviews yet.

Be the first to review “ProtectGuard® MG”